Page #33 |
INSTALLATION MANUAL |
STEP 11: PAGE 4 OF 4 |
| 1. AFTER UNPACKING SCREEN DOOR, LOCATE THE BLACK PLASTIC
HANDLE LATCH. THIS LATCH SHOULD BE FACING THE INSIDE OF THE OPENING WHEN THE DOOR IS
INSTALLED. 2. ANTI-RATTLE DEVICES ARE SUPPLIED IN HARDWARE PACK. IF NEEDED, SNAP INTO TOP OF DOOR AT THIS TIME. (2 BLACK PLASTIC PIECES) 3. PLACE THE TOP OF THE DOOR INTO THE CHANNEL ON THE UPPER FRAME. PUSH THE DOOR UP TO COMPRESS THE TOP ROLLERS. 4. WHILE HOLDING PRESSURE AGAINST THE TOP ROLLERS, SWING THE BOTTOM OF THE DOOR INTO THE BOTTOM TRACK. COMPRESS EACH OF THE TWO BOTTOM ROLLERS AND PLACE THE GROOVE OF THE ROLLER OVER THE BOTTOM TRACK. (SEE STEP 1) 5. W" A PHILLIPS SCREWDRIVER TURN SCREWS AT THE BOTTOM OF THE SCREEN DOOR CLOCKWISE TO RAISE THE DOOR OFF THE TRACK. .ADJUST RANGE = 3/8", TOP & BOTTOM. WARNING: DO NOT OVER ADJUST, THE DOOR SHOULD BE ADJUSTED SO THAT THE LOCK STILE IS PARALLEL TO THE LOCKING JAMB AND THE BOTTOM OF THE DOOR DOES NOT DRAG ON THE TRACK AT ANY POINT OF TRAVEL. 6. ADJUST THE TOP ROLLER UP IF NECESSARY TO CON- TACT THE FRAME HEADER. (TURNING THE ADJUSTMENT SCREW CLOCKWISE RAISES THE ROLLERS). THE DOOR SHOULD MOVE FREELY THROUGHOUT IT'S RANGE OF TRAVEL. 7. WITH THE CATCH SLIDE IN THE UPPER POSITION, LOCATE THE STRIKE PLATE 1/4" DOWN FROM THE CATCH. SECURE THE STRIKE PLATE TO THE JAMB WITH THE TWO SCREWS PROVIDED. (SEE STEP 2) 8. IF A BUG SEAL IS PROVIDED AND IS TOO WIDE, RIP OFF EXCESS AT TEAR-OFF GROOVE. CUT OFF ANY EXCESS LENGTH. (SEE STEP 3) * NOTE: USE OF A POWER SCREWDRIVER INCREASES THE POSSIBILITY OF STRIPPING THE ADJUSTMENT SCREW. |
 |