Page #28 |
INSTALLATION MANUAL |
STEP 10: PAGE 1 OF 2 |
PEDESTRIAN DOOR INSTALLATION
MATERIAL NEEDED
Unlike the Sliding Door, The Pedestrian Door is placed in the
wall the same way a Module is. Its sides are constructed with either a male or female
mullion. The single frame is assembled while the double frame will require some assembly.
With the Single Door Frame Assembly, cut the top to the proper height (follow same procedure as in Dia.8.5), Place the frame in line with the rest of the wall. Before securing the Door Frame, attach the threshold to the Bottom Track. Next square and level the frame and secure to the Header and Bottom Track with either #8 x l /2" Tek Screws or Pop Rivets.
Cut bottom portion of Hinge channel to fit in door frame. Attach the hinge to the door frame. Start by securing one hole in the top hinge to the door frame with a 3/8" x 1/2" Tek screw. Determine that the Hinge Channel is tight with the bulb vinyl on the door frame when closed. Next, secure in one hole with Tek screw, recheck the alignment. Now drill all holes of the hinges with a 3/8" drill bit and secure with # 64 x 1/8" Pop Rivets.
Place door in Hinge Channel and square up with the Door Frame. Secure with # 46 x 1/8" Pop Rivets four even locations both on the inside and outside through the Hinge Channel into the door. Cut the Bottom Adjustment Channel to fit from the edge of the door to the inside edge of the Hinge Channel. Place on the bottom of the door and adjust so that the Bottom Adjustment Channel brushes along the Threshold. Secure to Door with a couple of #46 x 1 /8" Pop Rivets.